Vallas Composite MálagaComposite & timber fencing
Close-up of a horizontal timber slat fence
Care guide

Cleaning composite and timber fences

Most fence stains on the coast come from the same few sources: trees, irrigation water, metal, barbecues and damp shade. This guide covers how to deal with each without harming the boards.

Technical guidesLast reviewed: Bauman Raymond Attila

What is the basic cleaning routine?

In short: rinse, wash with a soft brush, water and a mild detergent, then rinse again – working with the grain or along the boards.

For most dirt on composite – dust, pollen, cobwebs, light marks – plain water, a mild household detergent and a soft brush are enough. Work along the length of the boards, especially on embossed or brushed surfaces, and rinse well so detergent does not dry on.

For timber, the same routine removes surface dirt. If the fence is due for re-coating, cleaning comes first so the new finish bonds to sound wood.

Before using any product, check the board or coating manufacturer's care instructions. Some prohibit specific chemicals or methods, and following them protects any product warranty the manufacturer offers.

How do you deal with mould and algae?

In short: clean it off with a product the manufacturer approves, then reduce the damp and shade that caused it.

Research summarised by the US Forest Products Laboratory notes that composites are subject to mould growth outdoors. On a fence it shows as dark spots or a green film, usually on the shaded side, near the ground or behind plants.

Cleaning removes it, but it will return unless the cause changes. Typical causes on the coast:

  • sprinklers wetting the boards every day
  • soil, mulch or plant pots against the bottom board
  • dense planting that keeps the fence shaded and damp

A dry base – a low wall or base board – prevents much of this. See composite fence on a low wall.

What about leaf, rust and grease stains?

In short: each has a different cause and treatment, and the safest approach is to act early and use products the manufacturer allows.

Stains are easier to remove when fresh. On composite, aggressive scrubbing or abrasive pads can change the surface texture and leave a patch that looks different from the rest of the fence, so test any method on a hidden area first.

Leaf and fruit stains

Tannins from leaves, flowers and fruit – common under trees and bougainvillea – leave brown marks, especially on new boards. Prompt washing usually removes them; persistent marks may need a cleaner the manufacturer recommends.

Rust stains

Rust marks come from metal objects resting on the fence, steel fixings, or water dripping from rusty railings above. Remove the source first, then treat the stain as the manufacturer advises.

Grease and barbecue marks

Fat and smoke near a barbecue stain composite and timber. Wipe spills quickly with warm soapy water. Better still, keep the barbecue away from the fence for safety as well as cleanliness.

Can you use a pressure washer?

In short: only if the manufacturer allows it, and then with care – too much pressure close up can damage the surface.

Some composite manufacturers accept pressure washing with limits on distance and pressure; others advise against it. On timber, high pressure can raise and tear the fibres, leaving a rough surface that weathers faster. If in doubt, a hose and brush is the safer choice. The care instructions supplied with your boards are the reference here, and our page on composite and timber care explains how design choices reduce cleaning in the first place.

What is different about cleaning timber?

In short: timber can be cleaned more vigorously and then re-coated, but grey fibres and old finish must come off first.

Unlike composite, timber can be lightly sanded and refinished, which is one of its real advantages. Grey, weathered fibres on the surface should be removed before re-coating, using a cleaner or brightener intended for wood and compatible with the next coat. Then the stain or oil goes on as the product instructions say. Our timber fencing page and the guide on pressure-treated timber cover the rest.

What should you avoid?

In short: harsh solvents, abrasive tools, products the manufacturer forbids, and leaving the cause of a stain in place.

  • Do not use solvents, bleach or acids unless the manufacturer explicitly allows them.
  • Do not use wire brushes or abrasive pads on composite.
  • Do not paint composite to hide stains; paint may not bond and can make things worse.
  • Do not leave pots, metal furniture or tools leaning on the fence.
  • Do not keep watering the fence with the sprinklers.

If stains keep returning on a new fence, the cause is usually water or shade – a design question rather than a cleaning one.

Official sources

BR
Bauman Raymond Attila
Author and person responsible · Last reviewed:
FAQ

Frequently asked questions

What is the safest cleaner for composite?

Water, a mild detergent and a soft brush. For anything stronger, follow the board manufacturer's care instructions.

Why does my composite fence have black spots?

Usually mould, which grows on composite in damp, shaded places. Clean it and reduce the moisture source.

Can I use bleach on composite?

Only if the manufacturer allows it. Some products react badly to bleach or strong chemicals.

How do I remove rust marks?

Remove the metal causing them first, then use a method approved by the board manufacturer. Test on a hidden spot.

Will stains from new boards fade?

Some tannin marks on new composite fade with washing and weathering. Persistent ones may need a recommended cleaner.

Can I sand composite boards?

Generally no; sanding can damage the surface or the cap. Timber, on the other hand, can be sanded and refinished.

How often should I clean the fence?

Whenever it looks dirty, and at least once before the summer is a good habit. Fences under trees or near irrigation need it more.

Does cleaning affect the warranty?

It can, if forbidden methods or products are used. Keep the manufacturer's care instructions and follow them.

What causes green film at the bottom of the fence?

Algae or mould fed by damp soil, mulch or sprinkler water. Keeping the base dry is the long-term fix.

Do you offer fence cleaning?

No, we build fences. We explain at handover how to care for them.

Get a quote

Planning a composite or timber fence?

Send photos and the approximate length by WhatsApp or the form. We reply with what to check and an itemised quote, no commitment.