What can go wrong while building a composite fence?
A composite fence is a simple structure, but there are several points in the build where a shortcut becomes a problem later. Knowing them helps you ask the right questions before work starts.
What goes wrong at the setting-out stage?
In short: the fence ends up in the wrong place – on the neighbour's land, off line, or with uneven steps on a slope.
Setting out (*replanteo*) is the cheapest stage to get right and the most expensive to get wrong. Common problems: the line is assumed rather than confirmed, the neighbour was not consulted, or the levels on a sloping plot were not planned so the steps come out uneven. We mark the line and the posts on site and confirm them with you before any digging. For boundary questions, see the main site's guide on boundaries and party walls.
What surprises can the ground hold?
In short: rock, old concrete, loose fill, roots and buried pipes or cables.
Terraced plots on the coast are often built on made-up ground, and old gardens hide previous foundations, irrigation and cables. Each can change how footings are made. A careful contractor asks about services before digging and stops to discuss when something unexpected appears, rather than pouring a shallow footing and moving on. If something is uncertain at quote stage, we note it in the itemised quote.
Why do posts lean after a few storms?
In short: posts that are too light, footings that are too small or set in loose fill, or concrete loaded before it has gained strength.
A closed composite screen passes all its wind load to the posts. Leaning fences almost always trace back to one of three things: an undersized post for the height, a footing that does not reach firm ground, or boards fitted before the concrete was ready. We size posts and footings according to the system's instructions and the ground we find, and we do not hurry the boards onto fresh concrete. The composite fence with posts page explains the structure.
What goes wrong when the boards go in?
In short: missing expansion gaps, mixed components, rigid fixings and boards in contact with soil.
The typical faults appear only after the first hot spell: boards bowing, lifting out of channels or cracking at screws. The causes are boards cut too tight, fixings that pin the board, or components from different systems. Boards touching soil or mulch also cause staining and mould. Our guide on expansion gaps explains the principle; on a vertical composite fence the same applies to the top and bottom of each board.
What can go wrong with the wall and pillars?
In short: footings too small, pillars out of plumb, and fixings that do not suit the board system.
When a fence includes a low wall, the masonry has to be built for the board system: pillars plumb and at the right spacing, channels or fixings placed correctly, and a footing that suits the ground. And to be clear: a low wall under a fence is not a retaining wall. If the boundary holds back soil, that needs a technician's design, which is not a service we offer. The composite fence on a low wall page covers the details.
What goes wrong with communication, especially from abroad?
In short: decisions made without the owner, and problems hidden under concrete – solved by photo updates at key stages.
For owners abroad, the risk is not seeing the work before it is covered. We send photos at the key stages – setting out, footings, posts, boards – so you can see what is underneath the finished fence. If something unexpected comes up, we ask before deciding. Our article on what owners wish they had known has more on this.
Articles and guides

Common mistakes when choosing composite fencing
Most disappointing composite fences were chosen badly rather than built badly. These are the decisions we see go wrong most often – and what to do instead.
View details →Composite fence with posts
A lighter way to build a composite screen: posts set in concrete footings with boards slotted or fixed between them. Ideal for rear gardens and side boundaries where a full wall is more than you need.
View details →
Expansion gaps in composite fences
Composite boards grow and shrink with temperature. On a hot Costa del Sol afternoon that movement is real, and a fence built without room for it will show it. Here is why gaps matter.
View details →
Vertical composite fencing
Turning the boards upright changes the look and the way a fence is built. Vertical composite fencing gives a contemporary, taller-looking screen and copes well with sloping gardens.
View details →Frequently asked questions
Why is my new composite fence leaning?
Usually because of undersized posts, shallow footings, loose fill or boards fitted before the concrete set. Each needs checking on site.
Why are my boards bowing?
Most often because they were fitted without enough room to expand, or because components from different systems were mixed.
What if you find pipes while digging?
We stop, discuss it with you and adjust the post positions or the footing if possible. Telling us what you know beforehand helps.
What if the ground is rock?
Rock changes the excavation method and sometimes the footing design. We note uncertain ground in the quote.
Can a fence be built on loose fill?
Footings need to reach firm ground. If that is not possible, we explain the options before building.
How do I know the footings were done properly?
Ask for photos of the footings before they are covered. We send them as standard to owners who are not on site.
What if the neighbour objects during the build?
That is why the line should be agreed before work starts. If a dispute arises, we pause until it is resolved.
Can rain delay the build?
Heavy rain can delay excavation and concrete work. We do not give fixed durations, but we keep you informed.
Who is responsible if something goes wrong?
When we build the whole fence, one team is responsible for the whole structure, from footings to boards.
Is a low wall under a fence a retaining wall?
No. If the boundary retains soil, a technician must design a retaining wall; we do not build them.
Planning a composite or timber fence?
Send photos and the approximate length by WhatsApp or the form. We reply with what to check and an itemised quote, no commitment.